IKEv2 Optional SA&TS Payloads in Child Exchange

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶

This Internet-Draft will expire on 17 February 2023.¶

Copyright Notice

Copyright (c) 2022 IETF Trust and the persons identified as the document authors. All rights reserved.¶

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶

Table of Contents

1. Introduction

The Internet Key Exchange protocol version 2 (IKEv2) [RFC7296] is used to negotiate Security Association (SA) parameters for the IKE SA and the Child SAs. Cryptographic key material for these SAs have a limited lifetime before it needs to be refreshed, a process referred to as "rekeying". IKEv2 uses the CREATE_CHILD_SA exchange to rekey either the IKE SA or the Child SAs.¶

When rekeying, a full set of negotiation parameters are exchanged. However, most of these parameters will be the same as before, and some of these parameters MUST not change.¶

For example, the Traffic Selector (TS) negotiated for the new Child SA MUST cover the Traffic Selectors negotiated for the old Child SA. And in practically all cases, a new Child SA does not need to cover a wider set of Traffic. In the rare case where this would be needed, either a standard rekey could be used or a new Child SA could be negotiated followed by a deletion of the replaced Child SA.¶

Similarly, IKEv2 states that the cryptographic parameters negotiated for rekeying SHOULD NOT be different. This means that the security properties of the IKE or Child SA in practise do not change during a typical rekey.¶

This document specifies a method to omit these parameters and replace them with a single Notify Message declaring that all these parameters are identical to the originally negotiated parameters.¶

Large scale IKEv2 gateways such as Evolved Packet Data Gateway (ePDG) in 4G networks or Centralized Radio Access Network (cRAN/Cloud) gateways in 5G networks typically support more than 100,000 IKE/IPsec connections. At any point in time, there will be hundreds or thousands of IKE SAs and Child SAs that are being rekeyed. This takes a large amount of bandwidth and CPU power and any protocol simplification or bandwidth reducing would result in a significant resource saving.¶

For Internet of Things (IoT) devices which utilize low power consumption technology, reducing the size of the CREATE_CHILD_SA exchange for rekeying reduces its power consumption, as sending bytes over the air is usually the most power consuming operation of such a device. Reducing the CPU operations required to verify the rekey exchanges parameters will also save power and extend the lifetime for these devices.¶

When using identical parameters for the IKE SA or Child SA rekey, the SA and TS payloads can be omitted thanks to the optimization defined in this document. For an IKE SA rekey, instead of the (large) SA payload, only a Key Exchange (KE) payload and a new Notify Type payload with the new SPI are required. For a Child SA payload, instead of the SA or TS payloads, only an optional nonce payload (when using PFS) and a new Notify Type payload with the new SPI are needed. This makes the rekey exchange packets much smaller and the peers do not need to verify that the SA or TS parameters are compatible with the old SA parameters.¶

2. Conventions Used in This Document

3. Negotiation of Support for OPTIMIZED REKEY

To indicate support for the optimized rekey negotiation, the initiator includes the OPTIMIZED_REKEY_SUPPORTED notify payload in the IKE_AUTH exchange request. During this initial key request, the entire SA and TA payloads are included as normal. A responder that supports the optimized rekey exchange includes the OPTIMIZED_REKEY_SUPPORTED notify payload in its response. Note that the notify indicates support for optimized rekey for both IKE and Child SAs.¶

A responder that does not support the optimized rekey exchange processes the SA and TA payloads as normal, and does not include the new Notify. As per regular IKEv2 processing, a responder that does not recognize this new Notify, MUST ignore the notify. Responders may have been administratively configured with the optimization turned off for local reasons. The absense of the Notify indicates to the initiator that the optimization is not available, and normal, full rekey should be done.¶

When a peer wishes to rekey an IKE SA or Child SA, it MAY use the optimized rekey method during the CREATE_CHILD_SA exchange. If both peers have exchanged OPTIMIZED_REKEY_SUPPORTED notifies, peers SHOULD use the optimized rekey method for rekeys. Non-optimized, regular rekey requests MUST always be accepted.¶

The IKE_AUTH message exchange in this case is shown below:¶

Initiator                       Responder
--------------------------------------------------------------------
HDR, SK {IDi, [CERT,] [CERTREQ,]
    [IDr,] AUTH, SAi2, TSi, TSr,
    N(OPTIMIZED_REKEY_SUPPORTED)} -->
                            <-- HDR, SK {IDr, [CERT,] AUTH,
                                    SAr2, TSi, TSr,
                                    N(OPTIMIZED_REKEY_SUPPORTED)}

4. Optimized Rekey of the IKE SA

The initiator of an optimized rekey request sends a CREATE_CHILD_SA payload with the OPTIMIZED_REKEY notify payload containing the new Security Parameter Index (SPI) for the new IKE SA. It omits the SA payload.¶

The responder of an optimized rekey request replies with an included OPTIMIZED_REKEY notify with its new IKE SPI and also omits the SA payload.¶

Both parties send their nonce and KE payloads just as they would do for a regular IKE SA rekey.¶

Using the old SPI from the IKE header and the two new SPIs respectively from the initiator and responder's OPTIMIZED_REKEY payloads, both parties can perform the IKE SA rekey operation.¶

The CREATE_CHILD_SA message exchange in this case is shown below:¶

Initiator                       Responder
--------------------------------------------------------------------
HDR, SK {N(OPTIMIZED_REKEY,newSPIi),
         Ni, KEi} -->
                            <-- HDR, SK {N(OPTIMIZED_REKEY,newSPIr),
                                         Nr, KEr}

5. Optimized Rekey of Child SAs

The initiator of an optimized rekey request sends a CREATE_CHILD_SA payload with the OPTIMIZED_REKEY notify payload containing the new Security Parameter Index (SPI) for the new Child SA. It omits the SA and TS payloads. If the current Child SA was negotiated with Perfect Forward Secrecy (PFS), a KEi payload MUST be included as well. If no PFS was negotiated for the current Child SA, a KEi payload MUST NOT be included.¶

The responder of an optimized rekey request performs the same process. It includes the OPTIMIZED_REKEY notify with its new IKE SPI and omits the SA and TS payloads. Depending on the PFS negotiation of the current Child SA, the responder includes a KEr payload.¶

Both parties send their nonce payloads just as they would do for a regular Child SA rekey.¶

Using the old SPI from the REKEY_SA payload and the two new SPIs respectively from the initiator and responder's OPTIMIZED_REKEY payloads, both parties can perform the Child SA rekey operation.¶

The CREATE_CHILD_SA message exchange in this case is shown below:¶

Initiator                       Responder
--------------------------------------------------------------------
HDR, SK {N(REKEY_SA,oldSPI), N(OPTIMIZED_REKEY,newSPIi),
         Ni, [KEi,]} -->
                            <-- HDR, SK {N(OPTIMIZED_REKEY,newSPIr),
                                         Nr, [KEr,]}

6. Payload Formats

                     1                   2                   3
 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+---------------+-+-------------+-------------------------------+
| Next Payload  |C|  RESERVED   |         Payload Length        |
+---------------+-+-------------+-------------------------------+
|Protocol ID(=0)| SPI Size (=0) |      Notify Message Type      |
+---------------+---------------+-------------------------------+

 0                 1                   2                   3
 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+---------------+-+-------------+-------------------------------+
| Next Payload  |C|  RESERVED   |         Payload Length        |
+---------------+-+-------------+-------------------------------+
|Protocol ID    | SPI Size (=8) |      Notify Message Type      |
+---------------+---------------+-------------------------------+
|                Security Parameter Index (SPI)                 |
|                                                               |
+---------------------------------------------------------------+

7. IANA Considerations

This document defines two new Notify Message Types in the "IKEv2 Notify Message Types - Status Types" registry. IANA is requested to assign codepoints in this registry.¶

NOTIFY messages: status types            Value
----------------------------------------------------------
OPTIMIZED_REKEY_SUPPORTED                TBD1
OPTIMIZED_REKEY                          TBD2

8. Operational Considerations

Some implementations allow sending rekey messages with a different set of Traffic Selectors or cryptographic parameters in response to a configuration update. IKEv2 states this SHOULD NOT be done. Whether or not optimized rekeying is used, a configuration change that changes the Traffic Selectors or cryptographic parameters MUST NOT use the optimized rekey method. It SHOULD also not use a regular rekey method but instead start an entire new IKE and Child SA negotiation with the new parameters.¶

9. Security Considerations

The optimized rekey removes sending unnecessary new parameters that originally would have to be validated against the original parameters. In that sense, this optimization enhances the security of the rekey process by reducing the complexity and code required.¶

10. Acknowledgments

Special thanks to Valery Smyslov and Antony Antony.¶

Authors' Addresses